Allied Telesis AT-S100 - Manual (Page 204)

Chapter 6: 802.1x Access Control Commands
204 Section II: Advanced Configuration
SHOW DOT1X ALL
Syntax
show dot1x all
Parameters
none
Description
Use this command to display detailed 802.1x information about all of the
interfaces. To modify the lines displayed, use the | (output modifier token);
to save the output to a file, use the > (output redirection token).
Command Mode
Privileged Executive mode
Example
The following example shows the SHOW DOT1X ALL command and the
resulting display in Figure 24:
switch# show dot1x all
Figure 24. SHOW DOT1X ALL Command
(switch3)#show dot1x all
% 802.1x authentication enabled
% Radius server address: 192.168.1.1.1812
% Radius client address: dhcp128.ipinfusion.com.12103
% Next radius message id: 0
% Dot1x info for interface eth1 - 3
% portEnabled: true - portControl: auto
% portStatus: unauthorized - currentId: 11
% reAuthenticate: disabled
% abort:F fail:F start:F timeout:F success:F
% PAE: state: connecting - portMode: auto
% PAE: reAuthCount: 2 - rxRespId: 0
% PAE: quietPeriod: 60 - reauthMax: 2 - txPeriod: 30
% BE: state: idle - reqCount: 0 - idFromServer: 0
% BE: suppTimeout: 30 - serverTimeout: 30 - maxReq: 2
% CD: adminControlledDirections: in - operControlledDirections: in
% CD: bridgeDetected: false
% KR: rxKey: false
% KT: keyAvailable: false - keyTxEnabled: false