Allied Telesis AT-S100 - Manual (Page 258)

Chapter 11: Virtual Local Area Networks (VLAN) Commands
258 Section II: Advanced Configuration
SHOW VLAN ALL
Syntax
show vlan all
Parameters
none
Description
Use the SHOW VLAN ALL command to display information about all of the
VLANs, both static and dynamic, configured on the switch.
Command Mode
Privileged Executive mode
Example
The following example shows the SHOW VLAN ALL command and a
sample of the output:
switch3#show vlan all
See Figure 29 for an example display.
Figure 29. SHOW VLAN ALL
Related Commands
“SHOW MAC ADDRESS-TABLE VLAN” on page 102
“SHOW VLAN BRIEF” on page 260
(switch3)# show vlan all
VLAN ID
Name Type State Member ports
(u)-Untagged, (t) Tagged
======= ======= ====== ====== ========================
1 default STATIC ACTIVE ge1(u) ge2(u) ge3(u) ge4(u) ge6(u)
ge8(u) ge9(u) ge10(u) ge11(u) ge12(u)
ge13(u) ge14(u) ge15(u) ge16(u)
ge17(u) ge18(u) ge19(u) ge20(u)
ge21(u) ge22(u) ge23(u) ge24(u)
ge25(u) ge26(u) ge27(u) ge28(u) ge7(u)
3 VLAN0003 STATIC ACTIVE ge5(u) ge7(t)
4 VLAN0004 STATIC ACTIVE ge7(t)