Allied Telesis AT-S100 - Manual (Page 174)

Chapter 5: Interface Configuration Mode Commands
174 Section I: Command Modes
LACP SYSTEM-PRIORITY
Syntax
lacp system-priority <1-65535>
no lacp system-priority
Parameters
<1-65535> Specifies the LACP port priority. Lower numerical
values have higher priorities.
Description
Use the LACP SYSTEM-PRIORITY command to set the system priority of
a local system. This is used in determining the system responsible for
resolving conflicts in the choice of aggregation groups. The default value
is 32,768.
Use the no form of this command to reset the priority of the switch to the
default value.
Command Mode
Interface Configuration mode
Example
The following commands set the switch with an LACP priority of 6700:
switch#configure terminal
switch(config)#lacp system-priority 6700
Related Commands
none