Allied Telesis AT-S100 - Manual (Page 217)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 217
SET GVRP TIMER
Syntax
set gvrp timer join|leave|leaveall <1-65535> ge<1-28>
Parameters
default Returns the GARP timers to their default settings.
join Specifies the Join timer for joining the group. Enter a
value in centiseconds, which are one hundredths of a
second. The default is 20 centiseconds.
leave Specifies the Leave timer for leaving a group. Enter a
value in centiseconds, which are one hundredths of a
second. The default is 60 centiseconds.
leaveall Specifies the LeaveAll timer for leaving all groups.
Enter a value in centiseconds, which are one
hundredths of a second. The default is 1,000
centiseconds.
<1-65535> Specifies the timer value in hundredths of a second.
Enter a value between 1 and 65,535.
ge<1-28> Specifies a port. There are 28 ports on the 9000/28
switch. To specify a port, precede the port number
with “ge.”
Description
Use the SET GVRP TIMER command to set the GARP timers to join or
leave a group.
Note
You must make the settings for these timers the same on all GVRP-
active network devices.
Examples
The following command sets the Join timer to 0.1 second for all GVRP
applications on port 8:
switch#configure terminal
switch(config)#set gvrp timer join 10 ge8