Allied Telesis AT-S100 - Manual (Page 129)

AT-S100 Management Software User’s Guide
Section I: Command Modes 129
INTERFACE
Syntax
interface IFNAME
Parameters
IFNAME Specifies the name of an interface. There are 28 ports on
the AT-9000/28 and AT-9000/28SP switches. To specify
a port, precede the port number with “ge.”
Description
Use the INTERFACE command to access the Interface Configuration
command mode for the interface specified. After you enter the
INTERFACE command, “-if” is added to the prompt. For more information
about the commands included in the Interface mode, see “Interface
Configuration Command Mode” on page 20.
Command Mode
Configuration Terminal mode
Examples
The following commands access the Interface mode on interface 3 and the
resulting display:
switch#configure terminal
switch(config)#interface ge3
switch(config-if)#
The following commands access the Interface mode on interface 8 and the
resulting display:
switch#configure terminal
switch(config)#interface ge8
switch(config-if)#
The following commands access the Interface mode on VLAN 1 and the
resulting display (By default, all of the ports are assigned to VLAN 1.):
switch#configure terminal