Allied Telesis AT-S100 - Manual (Page 128)

Chapter 4: Configuration Terminal Mode Commands
128 Section I: Command Modes
HOSTNAME
Syntax
hostname NAME
Parameters
NAME Specifies the name of the switch. Enter a value between 1
and 63 alphanumeric characters. Names must start with a
letter and end with a letter or digit. Within the interior of
the name, there must only be letters, digits, and hyphens.
Description
Use the HOSTNAME command to assign a name to the switch. Enter a
value between 1 and 63 alphanumeric characters. The name must follow
the rules for ARPNET host names.
After you name the switch, the prompt changes to include the name. The
new name of the switch appears in all of the command modes.
Command Mode
Configuration Terminal mode
Example
The following example assigns “Switch3” as the name of the switch and
displays the new prompt:
none#configure terminal
none(config)#hostname Switch3
Switch3(config)#
Related Commands
none