Allied Telesis AT-S100 - Manual (Page 19)

AT-S100 Management Software User’s Guide
19
ˆ downloading new image files
ˆ displaying Ethernet port statistics
The prompt changes to “Switch#” to indicate the Privileged Executive
mode.
To access the Configuration Terminal mode from the Privileged Executive
mode, enter the CONFIGURE TERMINAL command. To return to the
Privileged Executive mode, enter the EXIT command.
See Table 2 for a sample list of commands that can be access from the
Privileged Executive command mode. See Chapter 3, “Privileged
Executive Mode Commands” on page 71 for detailed information about the
commands in this mode.
Configuration
Terminal Mode
The Configuration Terminal mode allows you to configure advanced
system features such as:
ˆ broadcast storm control
ˆ GVRP
ˆ IGMP Snooping
ˆ SNMP
ˆ STP and RSTP
To access this mode, you must first access the Privileged Executive mode.
Then type CONFIGURE TERMINAL to access the Configuration Terminal
mode. The prompt changes to “Switch(config)#” to indicate the software
has entered the Configuration Terminal mode. To return to the Privilege
Executive Mode, enter the EXIT command. To exit the management
session, enter the EXIT command again.
Table 2. Examples of Privileged Executive Mode Commands
Command Description
COPY RUN
START Saves the current configuration.
CONFIGURE
TERMINAL Changes the mode to the Configuration
Terminal Mode.
COPY Uploads the configuration file to an image or
configuration file.
SHOW
INTERFACE Displays interface configuration and status.
SYSTEM
FACTORY-
RESET Resets the AT-S100 software to the factory
default settings