Allied Telesis AT-S100 - Manual (Page 54)

Chapter 2: Configuring the AT-S100 Software
54
To disable the GVRP feature, enter the following commands:
switch# configure terminal
switch(config)# set gvrp disable
For more information about this command, see “SET GVRP” on page 212.
Setting the GVRP Applicant State
By setting the GVRP applicant state, you permit a port to process GVRP
information and transmit PDUs. The GVRP APPLICANT command sets
the GID applicant state on a port to active or normal. The syntax of this
command is:
set gvrp applicant state active|normal ge<1-28>
To set the GID applicant on port 5 to an active state enter the following
commands:
switch#configure terminal
switch(config)#set gvrp applicant state active ge5
For more information about this command, see “SET GVRP APPLICANT”
on page 213.
Enabling Dynamic VLANs
To enable dynamic VLANs to be created on the switch, use the GVRP
DYNAMIC-VLAN-CREATION command. The syntax of this command is:
set gvrp dynamic-vlan-creation
The following commands allow GVRP VLANs to be created dynamically:
switch#configure terminal
switch(config)#set gvrp dynamic-vlan-creation
For more information about this command, see“SET GVRP DYNAMIC-
VLAN-CREATION” on page 214
Setting GVRP Registration
You can allow manual creation of VLANs (fixed), deregister all existing
VLANs with the exception of VLAN 1 (forbidden), and allow dynamic
VLAN creation on a per port basis (normal).
The syntax of this command is:
set gvrp registration fixed|forbidden|normal ge<1-28>