Allied Telesis AT-S100 - Manual (Page 77)

AT-S100 Management Software User’s Guide
Section I: Command Modes 77
CLEAR MAC ADDRESS-TABLE STATIC
Syntax
clear mac address-table static|address HHHH.HHHH.HHHH
|interface ge<1-28>|vlan VID
Parameters
address Specifies a MAC address in the following format:
HHHH.HHHH.HHHH
interface Specifies the name of an interface. There are 28 ports on
the 9000/28 and 9000/28SP switches. To specify a port,
precede the port number with “ge.”
VID Specifies the VLAN ID. Use a value between 1 and 4094.
Description
Use the CLEAR MAC ADDRESS-TABLE STATIC command remove static
MAC addresses from the switch. You can remove all of the static MAC
addresses, specific MAC addresses, or all MAC addresses assigned to an
VLAN.
For procedures to configure and display the MAC addresses, see
“Displaying and Setting MAC Addresses” on page 32.
Command Mode
Privileged Executive mode
Examples
To remove static MAC address 0000.cd28.0752 from the MAC address
table, enter the following command:
switch#clear mac address-table static address
0000.cd28.0752
To remove all static MAC addresses from the MAC address table, enter
the following command:
switch#clear mac address-table static