Allied Telesis AT-S100 - Manual (Page 249)

AT-S100 Management Software User’s Guide
Section II: Advanced Configuration 249
SPANNING-TREE FORWARD-TIME
Syntax
spanning-tree forward-time <4-30>
no spanning-tree forward-time
Parameters
none
Description
Use the SPANNING-TREE FORWARD-TIME command to set the time, (in
seconds), after which (if this bridge is the root bridge) each interface
changes to the learning and forwarding states. This value is used by all
instances. The default value is 15 seconds.
Use the no form of this command to restore the default value of 15
seconds.
Command Mode
Configuration Terminal mode
Example
The following commands set the forward delay time to 20 seconds:
switch#configure terminal
switch(config)#spanning-tree forward-time 20
Related Commands
“SPANNING-TREE MAX-AGE” on page 251