Allied Telesis AT-S100 - Manual (Page 68)

Chapter 2: Configuring the AT-S100 Software
68
switch(config)# interface ge18
switch(config-if)# user-priority 4
For more information about this command, see “USER-PRIORITY” on
page 193.
To assign a weight of 10 to queue 3, use the following commands:
switch# configure terminal
switch(config)# mls qos 0 0 0 0 0 0 10 0 0 0 0 0 0 0 0 0
Note
Repeat the MLS QOS command for each queue.
For more information about this command, see “MLS QOS” on page 143.
To set CoS mapping on port 12 with a user priority of 7 and a traffic class
of 8, enter the following commands:
switch# configure terminal
switch(config)# interface ge12
switch(config-if)# traffic-class-table user-priority 7
num-traffic-classes 8
For more information about this command, see “TRAFFIC-CLASS-TABLE
USER-PRIORITY NUM-TRAFFIC-CLASSES” on page 192.