Allied Telesis AT-S100 - Manual (Page 75)

AT-S100 Management Software User’s Guide
Section I: Command Modes 75
CLEAR MAC ADDRESS-TABLE MULTICAST
Syntax
clear mac address-table multicast|address MACADDR
|interface ge<1-28>|vlan VID
Parameters
address Specifies a multicast MAC address in the following
format:
HHHH.HHHH.HHHH
interface Specifies the name of an interface. There are 28 ports on
the 9000/28 and 9000/28SP switches. To specify a port,
precede the port number with “ge.”
VID Specifies the VLAN ID. Use a value between 1 and 4094.
Description
Use the CLEAR MAC ADDRESS-TABLE MULTICAST command to
remove a multicast MAC address from the switch. You can remove all of
the multicast MAC addresses, specific multicast MAC addresses, or all
multicast MAC addresses assigned to an VLAN.
For procedures to configure and display the MAC addresses, see
“Displaying and Setting MAC Addresses” on page 32.
Command Mode
Privileged Executive mode
Examples
To remove multicast MAC address 0100.5100.0001 from the MAC
address table, enter the following command:
switch#clear mac address-table multicast address
0100.5100.0001
To remove all multicast MAC addresses from the MAC address table,
enter the following command:
switch#clear mac address-table multicast