Allied Telesis AT-S100 - Manual (Page 115)

Section I: Command Modes 115
Chapter 4
Configuration Terminal Mode
Commands
The commands in this chapter are accessed through the Configuration
Terminal mode. The commands in this mode allow you to configure
debugging, MAC addresses, and Network Time Protocol (NTP)
commands.
This chapter contains the following commands:
ˆ “CLOCK SUMMER-TIME RECURRING” on page 117
ˆ “CLOCK TIMEZONE” on page 119
ˆ “CRYPTO KEY GENERATE USERKEY” on page 121
ˆ “DOT1X SYSTEM-AUTH-CTRL” on page 123
ˆ “ENABLE PASSWORD” on page 124
ˆ “ENABLE SECRET” on page 125
ˆ “EXIT” on page 126
ˆ “HOSTNAME” on page 128
ˆ “INTERFACE” on page 129
ˆ “IP IGMP SNOOPING” on page 131
ˆ “IP ROUTE” on page 132
ˆ “IP SSH RSA KEYPAIR-NAME” on page 133
ˆ “IP SSH VERSION” on page 134
ˆ “LINE CONSOLE” on page 135
ˆ “LINE VTY” on page 136
ˆ “MAC ADDRESS-TABLE AGEING-TIME” on page 138
ˆ “MAC ADDRESS-TABLE STATIC DISCARD” on page 139
ˆ “MAC ADDRESS-TABLE STATIC FORWARD” on page 141
ˆ “MLS QOS” on page 143
ˆ “NTP AUTHENTICATE” on page 145
ˆ “NTP AUTHENTICATION-KEY” on page 146
ˆ “NTP SERVER” on page 148
ˆ “NTP TRUSTED-KEY” on page 150
ˆ “SHOW LIST” on page 151
ˆ “SHOW RUNNING-CONFIG” on page 153