Allied Telesis AT-S100 - Manual (Page 73)

AT-S100 Management Software User’s Guide
Section I: Command Modes 73
CLEAR MAC ADDRESS-TABLE DYNAMIC
Syntax
clear mac address-table dynamic|address HHHH.HHHH.HHHH
|interface ge<1-28>|vlan VID
Parameters
address Specifies a MAC address in the following format:
HHHH.HHHH.HHHH
interface Specifies the name of an interface. There are 28 ports on
the 9000/28 and 9000/28SP switches. To specify a port,
precede the port number with “ge.”
VID Specifies the VLAN ID. Use a value between 1 and 4094.
Description
Use the CLEAR MAC ADDRESS-TABLE DYNAMIC command to remove
a dynamic MAC address from the switch. You can remove all of the
dynamic MAC addresses, specific MAC addresses, or all MAC addresses
assigned to an VLAN.
For procedures to configure and display the MAC addresses, see
“Displaying and Setting MAC Addresses” on page 32.
Command Mode
Privileged Executive mode
Examples
To remove dynamic MAC address 0030.846e.bac7 from the MAC address
table, use the following command:
switch#clear mac address-table dynamic address
0030.846e.bac7
To remove all dynamic MAC addresses from the MAC address table, enter
the following command:
switch#clear mac address-table dynamic