HP LaserJet 4345 Multifunction Printer series User Manual
Page 227
Control panel message
Description
Recommended action
Mechanical Error
The ADF has experienced a mechanical
error.
Turn the MFP off then on. To temporarily
clear this message, touch IGNORE. If
the message persists, contact an HP-
authorized service or support provider.
See the HP support flyer or go to
Network connection required For
Digital Sending. Contact
administrator.
A digital-sending feature has been
configured, but a network connection is
not detected.
Verify the network connection. See
Solving network connectivity problems
.
Contact the network administrator.
NON HP SUPPLY INSTALLED
Economode disabled
A non-HP supply or a refilled HP supply
has been installed.
Follow the instructions in the onscreen
dialog box.
Novell Login Required
Novell authentication has been enabled
for this destination.
Enter Novell network credentials to
access the copy and fax features.
ORDER CARTRIDGE
The number of pages remaining for the
print cartridge has reached the low
threshold. The MFP was set to stop
printing when a supply needs to be
ordered.
Touch OK to continue printing until the
print cartridge is out of toner.
To order a new print cartridge, see
Ordering parts, accessories, and supplies
OUTPUT BIN
The specified output bin is full and
printing cannot continue.
Empty the bin to continue printing.
OUTPUT PAPER PATH OPEN
The paper path between the MFP and
the output device is open and must be
closed before printing can continue.
1.
If you have a 3-bin mailbox
installed, make sure the jam-access
door is closed.
2.
If you have a stapler/stacker
installed, make sure the staple
cartridge is snapped into position
and that the staple-cartridge door is
closed.
PAPER WRAPPED AROUND
FUSER
A jam has occurred because paper has
wrapped around the fuser.
Follow the instructions in the onscreen
dialog box. See
Password or name is incorrect.
Please enter correct login.
The user name or password was typed
incorrectly.
Retype the user name and password.
Phone Book is full. To add a
phone number, you must first
delete a phone number.
The MFP limits the number of phone
numbers that you can add.
Delete an unused phone number to add
a new one.
PIN is incorrect. Please enter a 4-
digit number.
The PIN format is incorrect.
Type the 4-digit PIN.
PIN is incorrect. Please re-enter
PIN.
The PIN was typed incorrectly.
Retype the PIN.
Please turn device off and install
hard disk.
The requested job requires a hard disk,
but the MFP does not have a hard disk
installed.
Turn the MFP off and install a hard disk.
See
.
Control-panel messages (continued)
ENWW
Resolving control-panel messages
213