HP LaserJet 4345 Multifunction Printer series User Manual
Page 224
Control panel message
Description
Recommended action
ADF Cover Open
The ADF cover is open.
Close the ADF cover. Follow the
instructions in the onscreen dialog box.
ADF OUTPUT BIN FULL
The ADF output bin holds 50 sheets of
paper. The MFP stops when the bin is full.
Remove the paper from the ADF output
bin.
ADF Paper Jam
Media is jammed in the ADF.
Follow the instructions in the onscreen
dialog box. See
.
ADF PICK ERROR
The ADF experienced an error while
picking media.
Make sure that your original contains no
more than 30 pages. Follow the
instructions in the onscreen dialog box.
ADF SKEW ERROR
Media has become skewed in the ADF.
Make sure that the paper guides are
aligned on the sides of the originals, and
that all of the originals are the same
size. Remove the remaining media from
the ADF and close the ADF cover.
Follow the instructions in the onscreen
dialog box.
Authentication information is
incorrect. Please re-enter
information.
A user name or password is incorrect.
Type the information again.
AUTHENTICATION REQUIRED
Authentication has been enabled for this
feature or destination. A username and
password are required.
Type the user name and password, or
contact the network administrator.
AUTHENTICATION REQUIRED
TO USE THIS FEATURE
A user name and password are required.
Type the user name and password, or
contact the network administrator.
BAD DUPLEXER CONNECTION
The duplex printing accessory is not
connected correctly to the MFP.
Remove and reinstall the duplexer. If this
message persists, contact an HP-
authorized service or support provider.
See the HP support flyer, or go to
BAD ENV FEEDER CONNECTION
The envelope feeder is not connected
properly.
Remove and reinstall the envelope
feeder. If this message persists, contact
an HP-authorized service or support
provider. See the HP support flyer, or go
.
CARTRIDGE FAILURE RETURN
FOR REPLACEMENT
The print cartridge still contains part of
the sealing tape.
Try to remove the remaining sealing
tape. If it cannot be removed, insert a
new print cartridge and return the faulty
print cartridge to receive a replacement.
(See
, or go to
CARTRIDGE OUT REPLACE
CARTRIDGE
The print cartridge is out of toner.
Printing cannot continue because
damage to the MFP might result.
Replace the print cartridge. (See
.)
CHECK CABLES CHECK
SCANNER LOCK To continue
turn off then on
The scanner might be locked or the
interface cable might be seated
incorrectly.
Make sure that the scanner is unlocked
and the interface cable is seated
correctly.
Control-panel messages (continued)
210
Chapter 10 Solving problems
ENWW