HP LaserJet 4345 Multifunction Printer series - Manual (Page 210)

6. If you can see either the leading edge or the trailing edge of the jammed media inside
the fuser, carefully pull it out.
7. If you can see the jammed media, but neither the leading edge nor the trailing edge is
visible, gently pull on the sides of the sheet of media until one edge becomes free. Then
carefully pull the jammed media out of the fuser.
8. If the media tears as you are removing it, turn the green dial on the fuser, and then
carefully pull out the jammed media. Go to step 13.
9. If you cannot see the jammed media inside the fuser, you must remove the fuser.
WARNING! The fuser is very hot. To avoid minor burns, wait 30 minutes for the fuser to cool before
removing it from the MFP.
a. To remove the fuser-entrance guide, push inward at the left edge to free the left-side
alignment pin. Then lift up slightly on the fuser-entrance guide, and remove it from
the MFP.
196 Chapter 10 Solving problems ENWW