HP StorageWorks 2.32 Edge Switch - Manual (Page 28)

Element Manager overview 28
Enable e-mail notification
The Simple Mail Transfer Protocol (SMTP) server and e-mail recipient addresses are configured in
HAFM (not in the Element Manager). E-mail notification is also initially enabled in HAFM for all
switches it manages. Note, however, that the e-mail notification option on the Element
Manager’s Maintenance menu must be enabled (checked) for e-mail notification to occur for the
specific switch.
The default setting for the Enable e-mail notification function is enabled (checked). To disable
the function, select Maintenance > Enable e-mail notification to clear the check box.
For additional information on using this option, see ”
Enabling e-mail notification ” on page 137.
Enable Call Home notification
Select Maintenance > Enable Call Home Notification to enable the call-home function for
the switch. The parameters of the call-home feature are configured in Windows ® . Refer to the HP
StorageWorks HA-Fabric Manager Appliance installation guide for instructions.
For additional information on using this option, see ”
Enabling or disabling call home notification ”
on page 138.
Backup and restore configuration
Select this option to save the product configuration stored on the switch to the HAFM appliance
hard disk or to restore the configuration data from the appliance. Only a single copy of the
configuration is kept on the appliance.
This backup is primarily for single-control processor (CTP) systems, where a backup is needed to
restore the configuration data to a replacement CTP card. You cannot modify the location or the
file name of the saved configuration.
For additional information on using this option, see ”
Backing up and restoring configuration data ”
on page 117.
NOTE: You can only restore the configuration to a switch with the same IP address.
Reset configuration
Select this option to reset all switch configuration data back to the factory defaults. When you
choose this option, a confirmation dialog box appears with a warning. For additional information
on using this option, see ” Resetting configuration ” on page 140.
CAUTION: This operation resets all configuration data, including any optional features that have
been installed. You will need to re-enter your feature key to enable all optional features after
resetting the configuration.
Help menu
Select the Help menu on the menu bar to display a list of the following options.