HP StorageWorks 2.32 Edge Switch User Manual
Page 180
Information and error messages
180
Cannot run diagnostics on a port
that is not installed.
Port diagnostics cannot be performed
on a port card that is not installed.
Run diagnostics only on a port that is
installed.
Cannot run diagnostics on a port
card that is not installed.
Port diagnostics (loopback tests)
cannot be performed on a port that
does not have a small form factor
(SFF) optical transceiver installed.
Install a transceiver in the port and
perform diagnostics again.
Cannot run diagnostics while a
device is logged-in to the port.
Port diagnostics (internal loopback
test) cannot be performed on a port
while an attached Fibre Channel
device is logged in.
Ensure the device is logged out and
perform diagnostics again.
Cannot run diagnostics while a
device is logged-in to the port.
A device is logged in to the port
where a diagnostic test is attempted.
Log out the device and run the diagnostic
test again.
Cannot save IPL configuration while
active=saved is enabled.
You cannot save the IPL file while the
active=saved property is set.
The FICON Management Server property,
active=save, must be disabled for HAFM
to save the IPL file.
Cannot save port configuration.
The port configuration cannot be
saved at the Element Manager
because the Ethernet link is down or
busy.
Retry the operation later. If the condition
persists, contact the next level of support.
Cannot save SNMP configuration.
The SNMP configuration cannot be
saved at the Element Manager
because the Ethernet link is down or
busy.
Retry the operation later. If the condition
persists, contact the next level of support.
Cannot set all ports to 1 Gb/sec
due to speed restriction on some
ports.
Appears if you try to set ports to
operate at 1 Gb/sec data speed
through the Configure Ports dialog
box and some ports do not support
speed configuration.
Replace ports that do not support speed
configuration with those that do support
more than one configuration.
Cannot set all ports to 2 Gb/sec
due to speed restriction on some
ports.
Appears if you try to set ports to
operate at 2 Gb/sec data speed
through the Configure Ports dialog
box and some ports do not support
speed configuration.
Replace ports that do not support speed
configuration with those that do support
more than one configuration.
Cannot set all ports to Negotiate
due to port speed restriction on
some ports.
Appears if you try to set all ports to
Negotiate through the Configure Ports
dialog box and some ports do not
support speed configuration.
Replace ports that do not support speed
configuration with those that do support
more than one speed configuration.
Table 8
Element Manager messages (continued)
Message
Description
Action