HP StorageWorks 2.32 Edge Switch - Manual (Page 167)

Edge Switch Element Manager user guide 167
Click OK to remove all contents
from log. This action deletes all contents from
the selected log. Click OK to delete the log contents or
Cancel to cancel the operation.
Connection to management server
lost. The connection to the remote HAFM
appliance has been lost. Log in to the HAFM appliance again
through the HAFM Log In dialog box.
Connection to management server
lost. Click OK to exit application. The HAFM application at a remote
workstation lost the network
connection to the HAFM appliance. Re-start the HAFM application to connect
to the HAFM appliance.
Could not export log to file. A log file input/output (I/O) error
occurred and the file could not be
saved to the specified destination.
The disk may be full or write
protected.
If the disk is full, use another disk. If the
disk is write protected, change the
write-protect properties or use another
disk.
Default zoning is not supported in
Open Fabric Mode.
A default zone cannot be enabled
when the product is enabled for
Open Fabric mode. Open Fabric
mode does not support zone
members defined by port numbers.
Change the Interop Mode from Open
Fabric to Homogeneous using the
Configure Fabric Parameters dialog box.
You can also redefine zone members by
the device WWN.
Device is not a member of a zone
in the active zone set.
The selected device is not a member
of a zone in the active zone set and
therefore cannot communicate with
the other devices in the route.
Enable the default zone or activate a zone
set containing the member before
attempting to show the route.
Download complete. Click OK and
start the HAFM.
Download of HAFM and the Element
Manager is complete.
Start the HAFM application to continue.
Duplicate community names
require identical write
authorizations.
If configuring two communities with
identical names, they must also have
identical write authorizations.
Verify that both communities with the same
name have the same write authorizations.
Duplicate Fabric Name. The specified fabric name already
exists.
Select another name for the fabric.
Duplicate name in zoning
configuration. All zone and zone
set names must be unique.
Every name in the zoning library
must be unique.
Modify (to make it unique) or delete the
duplicate name.
Duplicate nickname in nickname
configuration.
Duplicate nicknames cannot be
configured.
Modify the selected nickname to make it
unique.
Duplicate World Wide Name in
nickname configuration.
A World Wide Name can be
associated with only one nickname.
Modify (to make it unique) or delete the
selected World Wide Name.
Duplicate zone in zone set
configuration.
More than one instance of a zone is
defined in a zone set.
Delete one of the duplicate zones from the
zone set.
Duplicate zone member in zone
configuration.
More than one instance of a zone
member is defined in a zone.
Delete one of the duplicate zone members
from the zone.
Table 7 HAFM messages (continued)
Message Description Action