HP StorageWorks 2.32 Edge Switch - Manual (Page 168)

Information and error messages 168
Element Manager instance is
currently open.
A product cannot be deleted while
an instance of the Element Manager
is open for that product.
Close the Element Manager, then delete
the product.
Enabling this zone set will replace
the currently active zone set. Do
you want to continue?
Only one zone set can be active. By
enabling the selected zone set, the
current active zone set will be
replaced.
Click OK to continue or Cancel to end the
operation.
Error connecting to switch. While viewing routes, the HAFM
appliance was unable to connect to
the switch. The switch failed or the
switch-to-HAFM appliance Ethernet
link failed.
Try the operation again. If the problem
persists, contact the next level of support.
Error creating zone. The HAFM application encountered
an internal error.
Try the operation again. If the problem
persists, contact the next level of support.
Error creating zone set. The HAFM application encountered
an internal error.
Try the operation again. If the problem
persists, contact the next level of support.
Error deleting zone. The HAFM application encountered
an internal error.
Try the operation again. If the problem
persists, contact the next level of support.
Error deleting zone set. The HAFM application encountered
an internal error.
Try the operation again. If the problem
persists, contact the next level of support.
Error reading log file. The HAFM application encountered
an error while trying to read the log.
Try the operation again. If the problem
persists, contact the next level of support.
Error removing zone or zone
member.
The HAFM application encountered
an internal error.
Try the operation again. If the problem
persists, contact the next level of support.
Error transferring files
< message >.
An error occurred while transferring
files from the PC hard drive to the
HAFM application. The message
varies, depending on the problem.
Try the file transfer operation again. If the
problem persists, contact the next level of
support.
Fabric Log will be lost once the
fabric unpersists. Do you want to
continue?
When you unpersist a fabric, the
corresponding fabric log is deleted.
Click Yes to unpersist the fabric or No to
cancel the operation.
Fabric member could not be found. A fabric member does not exist when
the application prepared to find a
route, find a route node, or gather
route information on that fabric
member.
Ensure the product is incorporated into the
fabric and retry the operation. If the
problem persists, contact the next level of
support.
Fabric not persisted. You attempted to refresh or clear the
log, after a fabric was unpersisted.
When you unpersist a fabric, the
corresponding fabric log is deleted.
Click OK to continue. Ensure the fabric is
persisted before attempting to refresh or
clear the Fabric Log.
Field cannot be blank. The data field requires an entry and
cannot be left blank.
Enter appropriate information in the data
field.
Table 7 HAFM messages (continued)
Message Description Action