HP StorageWorks 2.32 Edge Switch - Manual (Page 138)

Using maintenance features 138
To enable and disable e-mail notification, select Maintenance > Enable E-Mail Notification.
Click this option again to disable it.
Enabling or disabling call home notification
Select Maintenance > Enable Call Home Notification to enable and disable Call Home
Notification for system problems. A check mark appears next to this option when the Call Home
Notification is enabled.
Backing up and restoring configuration
Select Maintenance > Backup & Restore Configuration to save the product configuration
stored on the switch to the HAFM appliance hard disk or to restore the product configuration from
the HAFM appliance. Only a single copy of the configuration is kept on the HAFM appliance.
Backup is primarily for single-CTP systems, such as the Edge Switch 2/24, where a backup is
needed to restore to a replacement CTP card. You can also use this feature for a special purpose
configuration or for temporary testing of a configuration. You cannot modify the location and file
name of the saved configuration.
NOTE: You can only restore the configuration to a switch with the same IP address.
NOTE: For the optional SANtegrity Binding feature, Backup and Restore Configuration will
backup and restore Switch Binding information, but will not back up and restore Fabric Binding
and Enterprise Fabric Mode information.
Backup procedure
Use the following procedure to back up your product configuration:
1. Select Maintenance > Backup & Restore Configuration to display the Backup and
Restore Configuration dialog box.
The Backup and Restore dialog box includes a short description of the features performed when
you click Backup or Restore.
Following is a list of configurations that are backed up to the HAFM appliance:
• Identification data (switch name, description, and location).
• Port configuration data (port names, blocked states, and extended distance settings).
• Operating parameters for fabric (E_D_TOV, R_A_TOV, switch priority, interop mode) and
for switch (preferred domain ID, rerouting delay, and domain RSCNs).
• SNMP configuration (trap recipients, community names, and write authorizations).
• Zoning configuration (active zone set and default zone state).
• Alternate Control Prohibited Settings.
2. To back up data, click Backup.