Modifying alerts – HP StorageWorks 2.32 Edge Switch User Manual
Page 114
Configuring the switch
114
Modifying alerts
Use the following steps to modify an existing threshold alert configuration.
1.
Select Configure > Threshold Alerts. The Configure Threshold Alerts dialog box appears.
2.
Select the alert that you want to modify by clicking the alert information in the table.
3.
If the alert is active, click Deactivate, then choose the alert information in the table again.
4.
Click Modify. An initial Modify Threshold screen displays where you can change the threshold
type.
5.
Select a threshold type from the drop-down list.
6.
Click Next when you are done. A Modify Threshold screen displays where you can change
the % utilization, cumulative minutes for the threshold to occur before notification, and the time
interval for measuring throughput and for alert notification.
7.
Make appropriate changes, then continue through the Modify Threshold screens, making
changes as necessary, until the summary screen displays the alert configuration.
8.
Perform either of the following steps:
• If you need to change any parameters, click Previous and Next to display the desired
Modify Threshold screen.
• Click Finish when you are done.
If you want to view the details of the modified threshold alert, follow the procedures in ”