HP StorageWorks 2.32 Edge Switch - Manual (Page 107)

Edge Switch Element Manager user guide 107
NOTE: If you click Activate, all current features will be replaced with new features. That is, if there
are features shown in the current list that are not shown in the new list, then those features will be
removed from the switch or director.
Because the switch or director is placed offline when you activate the Element Manager feature
key, the Element Manager will not launch until it comes back online and you either:
• Right-click the switch or director and click Element Manager.
• Choose the switch or director and click the Launch Element Manager icon on the tool bar.
Configuring date and time
Use the procedures in this section to display and change the date and time set on the switch. You
must set the current date and time on the switch using this dialog box so that the correct time
stamps display in the Event Log, Audit Log, Hardware Log, Link Incident Log, and Threshold Alerts
Log.
Set the switch date and time using the following steps:
1. Select Configure > Date/Time. The Configure Date and Time dialog box appears, as
shown in Figure 42 .
Figure 42 Configure Date and Time dialog box
2. You can set the switch date and time manually or you can set it for periodic synchronization
with the HAFM appliance. For specific instructions, see the following sections:
• ”
Setting date and time manually ”
• ” Synchronizing date and time ”