HP StorageWorks 2.32 Edge Switch - Manual (Page 175)

Edge Switch Element Manager user guide 175
You must define at least one remote
network address. At least one IP address for a remote
workstation must be configured for a
remote session to be activated. Define an IP address for at least one
remote workstation at the Remote Access
dialog box.
You must download the HAFM
client via the web install. An attempt was made to download
the HAFM application to a remote
workstation (client) using an
improper procedure. Download a compatible version of the
HAFM application to the remote
workstation (client) using the Web install
procedure.
Zones configured with port
numbers are ignored in Open
Fabric Mode. While in Open Fabric mode, zones
configured using port numbers are
enforced through World Wide
Names. Informational message only–no action is
required.
Zones must be defined before
creating a zone set. You cannot create a zone set without
any zones defined for HAFM. Define zones using the New Zone dialog
box.
Zoning by port number is ignored
in Open Fabric Mode. While in Open Fabric mode, zones
configured using port numbers are
enforced through World Wide
Names. Informational message only–no action is
required.
Zoning by port number is not
supported in Open Fabric Mode. You cannot specify an item for
zoning by port number if HAFM is in
Open Fabric Mode. Either define zones by WWN of device or
change to Homogeneous Fabric mode in
the Configure Operation Mode dialog box
of the Element Manager.
Zoning name already exists. Duplicate zone names are not
allowed in the zoning library. Modify (to make it unique) or delete the
duplicate zone name.
Table 7 HAFM messages (continued)
Message Description Action