HP StorageWorks 2.32 Edge Switch - Manual (Page 172)

Information and error messages 172
SANtegrity Feature not installed.
Please contact your sales
representative.
You selected Fabric Binding or
Enterprise Fabric Mode from
the Fabrics menu. These selections
are not enabled because the
optional SANtegrity binding feature
is not installed.
Install the SANtegrity Binding feature to
use Fabric Binding or enable Enterprise
Fabric Mode.
Select alias to add to zone. An alias was not selected before
clicking Add.
Select an alias before clicking Add.
Selection is not a World Wide
Name.
The selection made is not a World
Wide Name.
Select a valid World Wide Name before
performing this operation.
Server shutting down. The HAFM application is closing and
terminating communication with the
attached product.
Reboot the HAFM appliance. If the
problem persists, contact the next level of
support.
SNMP trap address not defined. If an SNMP community name is
defined, a corresponding SNMP trap
recipient address must also be
defined.
Enter a corresponding SNMP trap recipient
address.
Switch is not managed by HAFM. The selected switch or director is not
managed by the HAFM application.
Select a different switch or director.
The Administrator user cannot be
deleted.
The administrator user is permanent
and cannot be deleted from the
Configure Users dialog box.
Informational message only—no action is
required.
The Domain ID was not accepted.
The World Wide Name and
Domain ID must be unique in the
Fabric Membership List.
You attempted to add a detached
switch to the Fabric Membership List
through the Fabric Binding option
(SANtegrity Binding feature), but a
switch already exists in the fabric
with the same domain ID.
Enter a unique domain ID for the switch in
the Add Detached Switch dialog box.
The management server is busy
processing a request from another
Element Manager.
The HAFM appliance is processing a
request from another instance of an
Element Manager and cannot
perform the requested operation.
Wait until the process completes, then
perform the operation again.
The link to the managed product is
not available.
The Ethernet connection between the
HAFM appliance and managed
product is down or unavailable.
Establish and verify the network
connection.
The maximum number of aliases
has already been configured.
The maximum number of aliases
allowed was reached.
Delete an existing alias before adding a
new alias.
The maximum number of
management server network
addresses has already been
configured.
The number of HAFM appliance IP
addressees that can be defined to the
HAFM application has already been
configured.
Delete an existing IP address before
adding a new address.
The maximum number of members
has already been configured.
The maximum number of unique
members is 4097. The maximum
number of members is 8192.
Delete an existing zone member before
adding a new zone member.
Table 7 HAFM messages (continued)
Message Description Action