Resetting configuration, Using this option, see – HP StorageWorks 2.32 Edge Switch User Manual
Page 140
Using maintenance features
140
Resetting configuration
NOTE:
You must have maintenance authorization feature permissions to access this feature.
This option resets all configuration data input through options in the Configuration menu, zoning
configurations, and switch addressing to factory-default values. Since the current IP address for the
switch may not match the factory default address, the Ethernet link between the switch and the
HAFM appliance may drop and not reset.
Before using this option, record the switch’s current IP address, which appears below the switch’s
icon in the HAFM Physical/Topology Map view (Display Options set to Network Address).
You can also find the current IP address through the EWS interface.
After resetting the configuration, you must reset the original address on the switch through the
maintenance port or the EWS interface to maintain LAN connections and communication with the
HAFM appliance.
Use the following procedure to reset your product configuration:
1.
Set the switch offline. For instructions, see ”
2.
Select Maintenance > Reset Configuration. The following warning displays:
CAUTION! This operation will reset all switch configuration data and
non-volatile settings to factory default values. All optional features will
also be disabled. The switch must be offline to continue.
NOTE:
If you have enabled features that add additional port function since the switch was
shipped from the factory, these features will be disabled (factory default) when the configuration is
reset. Only those ports that were enabled at the factory will function. You will have to enable the
additional port function features again through the Configure Feature Key dialog box. See
Configuring a feature key” on page 104
for more information.
NOTE:
If you have enabled the Full Volatility feature through the switch's maintenance port since
the switch was shipped from the factory, this feature will be disabled (factory default) when the
configuration is reset.