HP StorageWorks 2.32 Edge Switch - Manual (Page 141)

Edge Switch Element Manager user guide 141
NOTE: Factory default values may vary, depending on the firmware release installed in your
switch. For a list of values, refer to the appropriate service manual for your Edge Switch.
3. Click Reset to reset all configuration data.
NOTE: If you have changed the switch‘s IP addressing from the factory default value, you may not
recover the Ethernet connection between the switch and the HAFM appliance because the Internet
Protocol (IP) address will reset to the factory default during this procedure.
For complete steps in recovering this connection, refer to the Reset Configuration Data procedure for
the Element Manager in the appropriate service manual for your Edge Switch.