HP StorageWorks 2.32 Edge Switch - Manual (Page 176)

Information and error messages 176
Element Manager messages
Table 8 lists Element Manager information and error messages in alphabetical order
Table 8 Element Manager messages
Message Description Action
A Preferred Path already exists
between this Source Port and this
Destination Domain ID. Please
re-configure the desired path. For any source port, only one path
may be defined to each destination
domain ID. On the Add/Change Preferred Path
dialog box, change the preferred path.
Activating this configuration will
overwrite the current configuration. Confirmation to activate a new
address configuration. Click Yes to confirm activating the new
address configuration or No to cancel the
operation.
All configuration names must be
unique. All address configurations must be
saved with unique names. Save the configuration with a different
name that is unique to all saved
configurations.
All FPM ports will be held inactive
while the director is configured to
2 Gb/sec speed. Do you want to
continue? Occurs when FPM cards are installed
in the director and director speed is
being set to 2 Gb/sec in the
Configure Switch Parameters dialog
box. Replace FPM cards with UPM cards (UPM
cards operate at 1 and 2 Gb/sec) or set
the director speed to 1 Gb/sec.
All port names must be unique. A duplicate Fibre Channel port name
was configured. All port names must
be unique. Reconfigure the Fibre Channel port with a
unique name.
All port names must be unique. A duplicate port name was entered.
Every configured port name must be
unique. Reconfigure the port with a unique name.
An Element Manager instance is
already open. Only one instance of the Element
Manager can be open at one time. Close the open Element Manager so the
desired instance of the Element Manager
can be opened.
Another Element Manager is
currently performing a firmware
install. Only one instance of the Element
Manager can install a firmware
version to the director at a time. Wait for the firmware installation process
to complete and try the operation again.
Are you sure you want to delete
firmware version? This message requests confirmation to
delete a firmware version. Firmware
library can store up to 8 firmware
versions. Click Yes to delete the firmware version or
No to abort the operation.
Are you sure you want to delete
this address configuration? Confirmation to delete the selected
address configuration. Click Yes to confirm the deletion of the
address configuration or No to cancel the
operation.