HP StorageWorks 2.32 Edge Switch - Manual (Page 155)

Edge Switch Element Manager user guide 155
Editing the Switch Membership list
Use the following procedure to edit the switch membership list:
1. Select Configure > Switch Binding > Edit Membership List. The Switch Binding
Membership List dialog box appears. The WWNs of devices and/or switches that can currently
connect to switch ports are listed in the Switch Membership List panel.
Figure 71 Switch Binding Membership List dialog box
NOTE: See ” Configuring switch binding overview ” on page 153 for information on how the
Switch Membership List is populated with WWNs according to options set in the Switch Binding
State Change dialog box.
2. If nicknames are configured for WWNs through HAFM and you want these to display instead
of WWNs in this dialog box, click the Display Options button at the bottom of the dialog
box. When the Display Options dialog box appears, click Nickname, then OK.
3. To prohibit connection to a switch port from a WWN currently in the Membership List, click the
WWN or nickname in the Membership List, then click the Remove button. The WWN or
nickname will move to the Attached Nodes panel. WWNs can only be removed from the
fabric if any of the following is true:
• The switch is offline.
• Switch Binding is disabled.
• The switch or device with the WWN is not connected to the switch.