HP StorageWorks 2.32 Edge Switch - Manual (Page 171)

Edge Switch Element Manager user guide 171
No zone member selected. A zoning operation was attempted
without a zone member selected.
Select a zone member and try the
operation again.
No zone selected. A zoning operation was attempted
without a zone selected.
Select a zone and try the operation again.
No zone selected or zone no
longer exists.
A zoning operation was attempted
without a zone selected, or the zone
selected no longer exists in the fabric.
Select a zone and try the operation again.
No zone set active. A zone set cannot be deactivated if
there are no active zones.
Informational message only—no action is
required.
No zone set selected. A zoning operation was attempted
without a zone set selected.
Select a zone set and try the operation
again.
No zone set selected or zone set no
longer exists.
A zoning operation was attempted
without a zone set selected, or the
zone set you selected no longer exists
in the fabric.
Select a zone set and try the operation
again.
Only attached nodes can be
displayed in this mode.
You cannot display unused ports
when adding ports by World Wide
Name.
Change the add criteria to Add by Port.
Password and confirmation don’t
match.
Entries in the password field and
confirmation password field do not
match. The entries are case sensitive
and must be the same.
Enter the password and confirmation
password again.
Remote sessions are not allowed
from this network address.
Only IP addresses of remote
workstations specified at the Remote
Access dialog box are allowed to
connect to the HAFM appliance.
Consult with the customer’s network
administrator to determine if the IP address
is to be configured for remote sessions.
Remote session support has been
disabled.
The connection between the specified
remote workstation and the HAFM
appliance was disallowed.
Consult with the customer’s network
administrator to determine if the
workstation entry should be modified at the
Remote Access dialog box.
Resource is unavailable. The specified operation cannot be
performed because the product is
unavailable.
Verify the HAFM appliance-to-product link
is up. If the link is up, the HAFM appliance
may be busy. Try the operation again
later.
Route data corrupted. The information for this route is
corrupt.
Try the operation again. If the problem
persists, contact the next level of support.
Route request timeout. The Show Route request timed out. Try the operation again. If the problem
persists, contact the next level of support.
Routing is not supported by the
switch.
This switch or director does not
support the Show Routes feature.
Select a different switch or director to show
the route.
Table 7 HAFM messages (continued)
Message Description Action