HP StorageWorks 2.32 Edge Switch - Manual (Page 106)

Configuring the switch 106
The list on the right is a set of features that come with the new feature key. All of the features
that are active are included in the new feature list.
Figure 40 Enable Feature Key dialog box
5. Click Activate to activate the new feature key.
An IPL will occur, during which the Ethernet connection between the HAFM appliance and
switch is momentarily interrupted. This will not disrupt Fibre Channel traffic.
NOTE: f you click Activate, all current features will be replaced with new features. That is, if there
are features shown in the current list that are not shown in the new list, then those features will be
removed from the switch.
6. When you are finished configuring the switch, you can back up the configuration data. For
more information, see ” Backing up and restoring configuration data ” on page 117.
No Feature Key dialog box
If you attempt to access a feature for which a feature key was not enabled, a No Feature Key
dialog box appears.
Figure 41 No Feature Key dialog box
At this point, you must enter the Element Manager feature key. After you enter a valid feature key,
the Enable Feature Key dialog box appears.
Click Activate on the Enable Feature Key dialog box to activate the new feature key. An IPL will
occur, during which the Ethernet connection between the HAFM appliance and director is
momentarily interrupted. This will not disrupt Fibre Channel traffic.