HP StorageWorks 2.32 Edge Switch - Manual (Page 94)

Configuring the switch 94
Configure Ports Procedure (FICON Management Style)
NOTE: This procedure applies only to the Edge Switch 2/32. FICON Management Style is not
available on the Edge Switch 2/24.
To configure Edge Switch 2/32 ports in FICON management style, use the following steps:
1. Select Configuration > Ports. The Configure Ports dialog box appears.
Figure 31 Configure Ports dialog box (FICON Management Style)
Ports are numbered from 0 through 31.
2. Enable or disable extended distance buffering for the port by clicking the check box in the
10-100 km column. When a check mark displays, extended distance buffering is enabled.
3. If a switch supports BB Credit, the RX BB Credit column replaces the 10-100km column.
Use this to set minimum and maximum allowable port BB credit values:
a. Right-click in the RX-BB Credit column to display the RX BB Credits dialog box as shown in
Figure 32 :
Figure 32 RX BB Credit dialog box