GW Instek GSP-930 User Manual - Manual (Page 78)

GSP-930 User Manual
76
Detection modes Auto Automatically chooses an
appropriate mode based on the
values of all the samples.
Normal While the signal level is constantly
increasing or decreasing, the
positive peaks are detected.
Otherwise, detecting mode
switches between positive peak
and negative peaks. Useful for
picking up burst phenomenon
while avoiding excessive noise.
Peak+ Detects positive peak signals by
selecting the maximum peak value
for each point from each bucket.
This mode is useful for sinusoidal
signals.
Peak- Detects negative peak signals by
selecting the lowest peak value for
each point from each bucket. This
mode is not recommended for
amplitude measurement.
Sample Randomly selects a value from the
bucket sample. Useful for noise
signals.
Average Calculates the average of all the
samples in the sample bucket.