GW Instek GSP-930 User Manual - Manual (Page 201)

REMOTE CONTROL
199
Configure RS232C
Background The RS232C interface is used for remote control
with a PC.
RS232C
Configuration
settings Baud Rate Stop bit: 1 (fixed)
Parity: none (fixed) Data bit: 8 (fixed)
Connection Connect an RS232C cable from
the PC to the rear panel RS232
port.
1. Press
System
>More 1/2[F7]>RmtInterface
Config>RS232 BaudRate[F4] to set the baud rate.
300 600 1200
2400 4800 9600
19200 38400 57600
115200
RS232C Remote Control Function Check
Functionality
check Invoke a terminal application such as MTTTY
(Multi-Threaded TTY).
To check the COM port No, see the Device
Manager in the PC. For WinXP; Control panel
→ System → Hardware tab.
Run this query command via the terminal after
the instrument has been configured for RS232
remote control (page 197).
*idn?
This should return the Manufacturer, Model