GW Instek GSP-930 User Manual - Manual (Page 199)

REMOTE CONTROL
197
Settings 1. Press
System
>More 1/2[F7]>RmtInterface>
LAN[F2]>LAN Config[F1] to set the LAN
settings:
IP Address[F1] Sets the IP address.
Subnet Mask[F2] Sets the subnet mask.
Default
Gateway[F3]
Sets the default gateway.
DNS Server[F4] Sets the DNS server address
LAN Config[F5] Toggles the LAN
configuration between DHCP
and manual settings.
2. Press Apply[F6] to confirm the LAN
configuration settings.
Display Icon The LXI icon turns green when connected
to a LAN and will flash if the
“Identification” setting is on, see page 201.
Set Password The password on the LXI webpage can be set
from the spectrum analyzer. The password is
shown in the system information.
By default the password is set to: lxiWNpwd
1. Press
System
>More 1/2[F7]>RmtInterface
Config[F2]>LAN[F2]>LXIPassword[F2] to set
the password.
2. Enter the password using the
F1~F7 keys, as shown below, or
use the numeric keypad to enter
numbers:
7 8 9
6 5 4
1 2 3
/ 0
Limitations:
 No spaces
 Only 1~9, A~Z, a~z characters allowed