GW Instek GSP-930 User Manual - Manual (Page 124)

GSP-930 User Manual
122
Trigger Mode[F3] Sets the triggering mode:
Nor.: Normal trigger
Sgl.: Single trigger
Cont.: Continuously
trigger
Trigger Level[F4] Sets the trigger level as a
percentage of the depth.
Trigger Delay[F5] Sets the trigger delay
time:
0 to 1ks
Run Now[F6] Turns FreeRun mode off
and uses the user-
defined trigger settings.
Note
The MAX and MIN measurements are held until
higher or lower values are found. To reset the MAX
and MIN measurements, press
Meas
>
Demod[F2]>AM Analysis[F1]>Min/Max Reset[F3].