GW Instek GSP-930 User Manual - Manual (Page 42)

GSP-930 User Manual
40
Start and Stop Frequency
Description The start/stop frequency function will set the
start and stop frequency of the span.
Operation 1. To set the start frequency, press
Frequency
> Start
Freq[F2] and enter the frequency and unit.
2. To set the stop frequency, press
Frequency
> Stop
Freq[F3] and enter the frequency and unit.
Range:
Resolution:
Default Start frequency:
Default Stop frequency: 0kHz~3GHz
1Hz
0Hz
3GHz
Display
Start Frequency
Start Frequency Stop Frequency
Stop Frequency
Note
The start and stop frequency can change when the
span settings are used.
The stop frequency must be set higher than the
start frequency (for spans

0), otherwise the span
will be automatically set to 100Hz.