GW Instek GSP-930 User Manual - Manual (Page 55)

BASIC OPERATION
53
2. Press Edit[F3].
The GSP-930 will split into two screens. The top
screen will show the waveform and the bottom
screen will provide an overview of the
correction points.
Spectrum display
Correction points
Frequency of
selected point
3. Press Point Num[F1] and choose a point number
to edit.
Point Num: 1~30
4. Press Frequency[F2] and choose the frequency of
the selected point.
Press Gain Offset[F3] and choose the amplitude
of the select point. The units will be the same as
those used for the vertical scale.
The frequency of the point values displayed in
the correction table on the bottom display.