Yokogawa DAQWORX - Manual (Page 207)

11-5 IM WX102-01E
1
2
3
4
5
6
7
8
9
10
11
Index
T
roubleshooting
Error Messages
No. Message/Corrective action
E3631 Communication not possible during logging.
Terminate Logger’s communication before executing.
E3632 Communication not possible while monitoring data.
Terminate Logger’s communication before executing.
E3633 Connected to unknown model.
Modify the system or change the settings.
E3636 Failed to send command.
Some items could not be set. Check the setup data.
E3637 Can’t reconstruct.
Displayed when the DR stand-alone model is connected.
E3638 Initial balancing failed.
Check the input, initialize, and perform initial balancing again. If it fails again, servicing is needed.
E3639 Incorrect file name!
Check the file name and extension.
E3640 File operation failed.
Check the free space on the PC’s hard drive. Check that the hard disk is operating properly.
E3641 These data were generated by another model.
Select a different file.
E3643 Failed to load data. Some data initialized.
Check the setup data.
E3644 Invalid channels are included in the copy source.
Check the copy source and copy destination settings.
E3645 Please enter an equation.
Enter an equation.
E3646 Unknown symbol is entered. Please change equation.
Check the setup data.
E3647 Invalid channel number is entered. Please change equation.
Check the channel number.
E3648 Incorrect use of parenthesis. Please change equation.
Check the setup data.
E3649 Grammatical error. Please change equation.
Check the setup data.
E3650 Character string is incorrect.
Check the setup data.
E3651 Invalid channel number.
Change the channel number.
E3652 For input range, please keep CH numbers: Left < Right.
Check the setup data.
E3653 Channel number is already being used!
Check the setup data.
Messages
No. Message/Corrective action
M3404 Invalid Project name. Please enter a new name.
M3405 This Project name is already being used. Please enter a new Project name.
M3406 There must be at least one unlocked Project.
M3407
Can't contain any of the following characters / : , ; * ? " < > |
M3031 Do you want to stop recording ?
M3032 Please stop Measuring before you exit.
M3033 You must Unlock and enter a Password to Exit.
M3231 Send Tags?
M3232 Send Tag IDs?
M3601 Start Receiving?
M3602 Start Sending?
M3603 Reconstruct?
M3604 File is already open. Reopen will cause your changes to be discarded. Do you want to reopen?
M3605 All settings will be initialized!
M3606 SET (Regular) settings will be initialized!
M3607 Add Unit?
M3608 Delete Unit?
11.2 Error Messages and Corrective Actions