Yokogawa DAQWORX - Manual (Page 10)

1-2 IM WX102-01E
3 Logger
Enables you to display DA100/DC100/DR measurement and calculated Math data
on your PC’s monitor, and save measurement, calculated Math and report data to its
harddisk. Allows you to set the interval for saving data, and for display renewal.
• Saving measurement data can be selected to start either,
• immediately, or,
• at a fixed time.
• Saving measurement data can be selected to end either,
• immediately, or,
• at a fixed time, or,
• after a fixed data number has been reached.
• Report data will be saved when created by DA100, DC100, or DR.
Logger itself can make daily report files.
On your PC you can display the following monitors:
Alarm monitor
Displays the alarm condition of each channel. Useful as alarm monitor.
Trend monitor
Displays both measurement and computed waveforms. Useful for trend observation.
Color monitor
Displays measurement and computed data in selected color. Useful for monitoring
trends for all measurement and computed data.
Meter monitor
Analog display of measurement and computed data. Depending on the aim of your
observation, choose either a bargraph, meter, or thermometer monitor.
Numeric monitor
Displays numeric values of both measurement and computed waveforms. Useful
when reading a large number of values at the same time.
Monitor settings can be connected by clicking the Link button.
An auto-processor automatically converts data logging and report files into Excel/ASCII/
Lotus 1-2-3 formats. Report files are automatically printed.
The monitor server that supplies network-connected personal computers with data, is
activated with Logger software.
4 Historical Viewer
Using Historical Viewer you can use the following 3 kinds of data to monitor waveforms,
numerical values, etc. on a PC screen, or to print them out.
• Measurement data saved to a harddisk using Logger software.
• Measurement data from earlier obtained software for DARWIN instruments (DOS or
Windows).
• Measurement data saved directly to a floppydisk from a DR/DC100.
It is possible to use a cursor to read the values of data on display, or make calculations
with selected data.
Data can be converted to Excel/ASCII/Lotus 1-2-3 formats, and then saved.
Report data can be displayed, printed, and their formats can be converted.
5 Tag Editor
Tag stands for an optional character string (such as a terminal or signal name) used to
distinguish waveforms in stead of graph and channel numbers. Use the 16 character ‘Tag
Comment’ or the 8 character ‘Tag No.’ For Logger or Historical Viewer software, the Tags
will be displayed instead of the channel number. It is possible to receive tag settings from
or send them to a DR/DC100. Tag settings are not possible for the DA100.
1.1 DAQ 32 Plus/DAQ 32 Plus Client Package Introduction