Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 60)

Teledyne LeCroy Start Recording
58 Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
You can limit the range of the saved file. You can save:
 All Trace
 Range between selected cursors
 Range between SCSI Commands or Transport
You can import SCSI Commands, Task Management, ATA Commands, SSP Frames, SMP
Frames, SMP Commands, or STP Frames.
You can select the Port.
In the Project Name, enter a valid file name.
Export to Trainer
The Export to Trainer dialog, accessible from the File menu, allows exporting data to a file
in a format supported by the timer.
Figure 2.11: Export to Trainer (SAS) Dialog
In the Export to Trainer dialog you can
 Limit the range of the saved file. You can save:
 All Traces
 Range between selected cursors
 Range between SCSI Commands or Transport
 You can import SSP Frames, SMP Frames, or STP Frames (see “Events and Event
Properties” on page 463 ).
 You can Insert Waits (see “Wait Commands” on page 438 ).
 You can use Auto Alignment (see “The Global Setting “AutoAlign”” on page 409 ).
 You can select the Port (see “Setup Menu” on page 398 ).
 Indicate Trainer Generation File Name and click Export to export the trainer
generation file.