Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 313)

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 311
Preferences Teledyne LeCroy
Color Setting
Based on Cell Type: Each column has its own color.
Based on Port No.: Data of each row are shown based on the specified color for its port.
You can set the color of ports in the Viewer settings.
Based on Read/Write Command Type: You can specify a color for Read commands,
another color for Write commands, and other color for other commands. The software
shows each row based on the command type: Read, Write, or others.
Based on Specific Command Type: You can specify a color for each command. The
software applies the setting on the Command column.
Anchor the Selection bar
You can anchor the selection bar of the Spreadsheet View.
Set the Anchor row as sync. point: Other views synchronize based on the contents of the
anchor row.
Other
Repeat decoded command in frame column: The spreadsheet shows the name of the
command in front of all frames in the Command column. Otherwise, it will show the
name of the command only in front of the SSP command frame.
Decode CDB of Commands: The spreadsheet shows name of command in command
column, otherwise shows CDB of command in command column.
Show ‘Sector Count’ instead of ‘Xfer Length’ (SATA only): Display sector count.