Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 36)

Teledyne LeCroy Connecting via Ethernet
34 Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
5. Using the extraction tool as a handle, gently wriggle the expansion card forward
about 1/8”.
6. Repeat steps 4 and 5 approximately three times, until the card is free from the
retaining screws and you can remove the card from the system.
1.10 Connecting via Ethernet
The Ethernet connection can have any of these configurations:
1. Analyzer connected to a network using a hub or switch, Gigabit Ethernet interface,
or similar device.
2. Analyzer connected to the host machine (machine running the application
software), using a hub or switch, Gigabit Ethernet interface, or similar device.
3. Analyzer connected directly to the host machine using a SATA cable.
1.11 Connecting to a Network
When connected to a network, the analyzer can communicate with the DHCP server to
obtain IP address configuration information in order to establish a connection. Refer to
“Select Device” on page 25 .