Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 477)

Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual 475
Resetting the Toolbar Teledyne LeCroy
Figure 5.33: Connection Parameters Dialog
You can set the “Identify” frame parameter settings to keep the link connected:
 Device Type: End Device, Edge Expander, or Fanout Expander
 SSP Initiator: Present or Not Present
 STP Initiator: Present or Not Present
 SMP Initiator: Present or Not Present
 SSP Target: Present or Not Present
 STP Target: Present or Not Present
 SMP Target: Present or Not Present
 SAS Address (hex): eight digits ‐ eight digits
 PHY Identifier (hex): two digits
 Zone Device: Yes or No
 Zone Broadcast Method (hex): two digits
You can select to not show the dialog until there is a generation mode change.
5.20 Resetting the Toolbar
The Analyzer Toolbar has the following:
 Show InFusion Frame: Switches to InFusion frame.
 Show Analyzer Frame: Switches to Analyzer frame.
 Start Analyzer: Start Analyzer without switching to Analyzer frame.
 Stop Analyzer: Stop Analyzer without switching to Analyzer frame.
 Abort Analyzer: Abort Analyzer without switching to Analyzer frame.
The Generator Toolbar has the following:
 Start Generation