Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 112)

Teledyne LeCroy Projects
110 Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
 To activate the Initiator Emulator on a port and run the Analyzer on the same
port, select InitiatorEmulator/Analyzer.
 To activate the InFusion on a port, select Jammer.
 To activate the Trainer on a port, select Trainer.
Sierra M6‐2 can have Analyzer and Trainer or Analyzer and Jammer on same port.
Note: To display the current Port Configuration, click the green button in the lower right corner to
display the Port Status window (see “Port Status” on page 293 ).
Port Configuration and Projects
Port Configuration depends on Project selected.
Performance Analyzer and Performance Analyzer with Initiator Emulator do not use
ports.
Protocol Analyzer, Protocol Analyzer with Initiator Emulator, and Target Emulator can
have the following port configurations.
Analyzers work with Emulators, Jammer, and Trainer (see below).
One Initiator Emulator can work by itself or work with one Analyzer.
One Target Emulator can work by itself or work with one Analyzer.
(Note that Host Emulator and Analyzer can be on one port and
Analyzer and Device Emulator can be on another port at the same time.)
Emulators do not work with Trainer.
Emulators work with Jammer (see below).
Project Number
One analyzer
and/or
one emulator
Two analyzers
and/or
two emulators
Protocol Analyzer Port 1. One analyzer each on
1 and 2.
Protocol Analyzer
with Initiator
Emulator Port 1.
Pair on Port 1.
One analyzer each on
Port 1 and Port 2.
One emulator each on
Port 1 and Port 2.
Target Emulator Port 1.
Pair on Port 1
One emulator each on
Port 1 and Port 2.