Teledyne LeCroy Sierra M6-2 SAS_SATA Protocol Analyzer User Manual - Manual (Page 204)

Teledyne LeCroy Target and Device Emulation
202 Sierra M6‐2 SAS/SATA Protocol Analyzer User Manual
Power Management Setting
Use the Power Management tab to manage power settings . Enter the relevant information in
the Host Initiated Power Management and Device Initiated Power Management panes.
Figure 2.197: Power Management Tab
2.12.12 Notes Tab
Click the Notes tab and enter a Project Name and a brief description of the
Target Emulation project (see
“Add a Project Note” on page 112 ).
2.12.13 Run Target Emulation
Click the Start Target Emulator button or select Session > Start Target Emulator
to start emulation.
Note: You can run the analyzer while device emulation is active to monitor bus traffic.
2.12.14 Device Emulator Settings (SATA only)
Click the Settings tab to display the Device Emulator Settings dialog.
The Settings tab opens with a default set of values, which you can modify. To return to
these values, click the Default Settings button.