IAI America ASEL User Manual
Page 68
Chapter 3 Installation and W
iring
Part 1 Installation
46
Part 1 Installation
6.8
Installation Method for the Absolute-Data Backup Battery
The ASEL controller does not come with a holder or any other dedicated piece for installing the absolute-
data backup battery. The user must affix the battery using tie-bands.
Example of installation
As shown to the left, guide tie-bands through the
controller and tie the ends to make loose loops.
Guide the batteries into the tie-band loops.
Tighten the tie-bands and cut off any excess length at
the end.
Connect each battery connector.
Pay attention to the connector orientation.
(The connector hook should face the left side when
viewed from the front of the controller.)
Caution: If the main power cannot be turned
on immediately after the encoder
cable has been connected, do not
connect the battery connector.
- ERC2 (138 pages)
- ERC2 (188 pages)
- ERC3 (438 pages)
- ERC (153 pages)
- RCA-E (53 pages)
- RCA-P (42 pages)
- RCB-101-MW (38 pages)
- RCP2-C (178 pages)
- RCS-E (102 pages)
- RCA-A4R (72 pages)
- RCA-RA3C (114 pages)
- RCA-SRA4R (56 pages)
- RCA2-RA2AC (100 pages)
- RCA2-SA2AC (92 pages)
- RCA2-TA4C (134 pages)
- RCD-RA1D (40 pages)
- RCP2-BA6 (72 pages)
- RCP2-GRSS (130 pages)
- RCP2-HS8C (126 pages)
- RCP2-RA2C (120 pages)
- RCP2-RTBS (80 pages)
- RCP2W-SA16C (46 pages)
- RCP3-RA2AC (60 pages)
- RCP4-RA5C (82 pages)
- RCP4-SA5C (94 pages)
- RCP4W (96 pages)
- RCS2-F5D (142 pages)
- RCS2-GR8 (46 pages)
- RCS2-RN5N (80 pages)
- RCS2-RT6 (60 pages)
- RCS2-SA4C (258 pages)
- RCS2-TCA5N (62 pages)
- RCL-SA1L (66 pages)
- RCL-RA1L (56 pages)
- RCLE-GR5L (46 pages)
- IK Series (16 pages)
- FS (84 pages)
- IF (76 pages)
- ISB (114 pages)
- ISDA (126 pages)
- ISDB (116 pages)
- ISPWA (90 pages)
- NS (78 pages)
- ICS(P)A (16 pages)
- RS (46 pages)