IAI America ASEL - Manual (Page 60)

Chapter 3 Installation and W
iring
Part 1 Installation
38
Part 1 Installation
6.5.2 PNP Specification
(1) Input part
External Input Specifications (PNP Specification)
Item Specification
Input voltage 24 VDC r10%
Input current 7 mA per circuit
ON/OFF voltage
ON voltage --- 8 VDC max.
OFF voltage --- 19 VDC min.
Insulation method Photocoupler insulation
External devices
[1] No-voltage contact (minimum load of approx. 5 VDC/1 mA)
[2] Photoelectric/proximity sensor (PNP type)
[3] Sequencer transistor output (open-collector type)
[4] Sequencer contact output (minimum load of approx. 5 VDC/1 mA)
[Input circuit]
* N: I/O interface pin No. 17B
Caution
If a non-contact circuit is connected externally, malfunction may result from leakage
current. Use a circuit in which leakage current in a switch-off state does not exceed 1
mA.
 ASEL controller’s input signal
At the default settings, the system recognizes the ON/OFF durations of input signals if they
are approx. 4 msec or longer. The ON/OFF duration settings can also be changed using I/O
parameter No. 20 (input filtering frequency).
In
te
rn
al
c
irc
ui
t
Input terminal
External power
supply 24 VDC 10%
N*
560 :
3.3 K:
ON duration OFF duration
+
-