CONTREX CX-1200 - Manual (Page 474)

I-1
APPENDIX I: SERIAL COMMUNICATIONS ERROR
CODE DEFINITIONS
# Name Definition
0 OK Request processed
1 General Data Error A non-specified error occurred as a result of the last
serial communications transmission. Check the
contents of the last message transmission against
the protocol definition.
2 Res Error The resolution for the Control Parameter value
exceeds the minimum or maximum that is allowed.
3 Invalid Parm The requested parameter does not exist.
4 String too long The custom engineering units string that was sent
exceeds the 15 character limit and was truncated to
15 characters.
5 Out of Range The parameter requested is above or below the
available number of parameters, or the address
requested for a memory read is not within the
memory address range.
6 Not Allowed The request is not allowed.
7 Lockout During RUN An attempt was made to change a parameter value
for a parameter that is locked out during run, while
the control is in run (state).
8 Not Ready The CX-1200 was “not ready” to receive the last
request.
9 Block Parm Error An error was encountered while processing a block
parameter request.
10 Block Value Error An error was encountered while processing a block
value request.
11 Parm Memory Limit The internal memory limit for block parameters was
exceeded during processing of a block parameter
change.
12 MIN Error There was an attempt to exceed the minimum value
allowed for a parameter value.
(Continued)